Контактор KNL16-22/Sp4/220/240V/50/60Hz

• Contactors are used for switching electric motors and other resistive
inductive and capacitive loads
• A wide variety of snap-on auxiliary switch blocks and accessories
• Uniform marking of connection terminals in accordance with EN 50005
and EN 50011
• Quick assembly to a 35 mm wide mounting rail in accordance with
EN 60715 or fixing with screws
• KNL6 - KNL18 are 4-pole and KNL22 - KNL30 are 3-pole contactors
• Open and funnel-shaped connection terminals - fast and simple
connection
• Plus/minus screws, protected against falling out - standard or posidrive
screwdrivers can be used
• High contact reliability at low voltages
• Possibility of individual marking on a special plate - easy identification of
a contactor in the circuit
• Auxiliary contact with a pushbutton function
• Uniform contactor width - 45 mm
• Assembly to vertical or horizontal surface with ±20° deviation
• Third coil terminal
• Possibility of direct connection of a bimetal relay for protection against
overload and in case of phase failure
• Version with all four main contacts (Sp4) (KNL9 - KNL18)
• Degree of protection IP20
• High electrical and mechanical endurance, and high switching capacity
• Existing version KNL18 St4 for utilization category AC-6b (300 uF)